[Grok-dev] Howto set up post-mortem debugging in Grok

Sebastian Ware sebastian at urbantalk.se
Fri Aug 17 08:01:47 EDT 2007

I can't find the section you are mentioning. Is this part of the new  
order of things? The solution I proposed works for me, but my Grok is  
from a couple of months ago.

Mvh Sebastian

17 aug 2007 kl. 13.50 skrev Wichert Akkerman:

> Previously Sebastian Ware wrote:
>> This is so easy, it is very difficult to find any simple
>> documentation... thus easy enough for me to contribute :) This
>> section should be part of a "Grok Debugging Howto"...
> I'm afraid it is not fully correct. The proper way to do this is by
> modifying the buildout configuration:
> in your buildout.cfg look for the zopectl section. You will see an  
> entry
> there that defines the zope.conf that should be used. Modify that to
> look like this:
>   zope.conf = ${data:zconfig}
>       <server>
>          type PostmortemDebuggingHTTP
>          address 8080
>       </server>
> if you rerun buildout your zope.conf will be updated to use the
> PostmortemDebuggingHTTP server.
> I had to figure out that yesterday as well :)
> Wichert.
> -- 
> Wichert Akkerman <wichert at wiggy.net>    It is simple to make things.
> http://www.wiggy.net/                   It is hard to make things  
> simple.
> _______________________________________________
> Grok-dev mailing list
> Grok-dev at zope.org
> http://mail.zope.org/mailman/listinfo/grok-dev

More information about the Grok-dev mailing list