[Zope] Re: [Zope-dev] The number of threads in z2.py file.
jmeile at hotmail.com
Thu Feb 19 15:37:39 EST 2004
> i'm using Zope-2.6.3, Red Hat-8.0, CMF-1.4.2, and
> CMFPlone-2.0-RC3. If the number of threads=4, the zope
> can start but cannot load into ZMI. After i change the
> number of threads=1, it can load into ZMI. Why?
It could be that when you compiled your python, you
didn't configure it to use threads (I'm not sure if 2.1.3
does this by default). However, before installing python again,
you had better to check the log as Dieter said. Perhaps it's
More information about the Zope